このエントリーをはてなブックマークに追加
ID 15385
Eprint ID
15385
フルテキストURL
著者
Uno, Yoshiyuki Department of Mechanical Engineering
Kubota, Shin-ichiro Department of Mechanical Engineering
Nakajima, Toshikatsu Department of Mechanical Engineering
Ogata, Kojiro Hitachi Construction Machinery Co., Ltd.
Tada, Nobuhiko Hitachi Construction Machinery Co., Ltd.
抄録
Direct patterning of copper coated ceramic circuit board is experimentally investigated with Q-switched Nd:YAG laser in order to shorten the time of the trial manufacture of electronic circuit board and to adapt the flexible design change. It is pointed out that the fast direct patterning the speed of which reaches about 100 mm/s is possible if the repetition frequency and the average power are selected properly. Furthermore cutting off and/or drilling of ceramic board are also possible under the condition that the repetition frequency is less than 3kHz. This technique makes it possible the mask1ess patterning of ceramic circuit board which has been widely used recently in place of conventional glass-epoxy or phenolic resin circuit board, and it leads to the shorter time limit of delivery as compared with the conventional end-milling method.
発行日
1992-11-25
出版物タイトル
Memoirs of the Faculty of Engineering, Okayama University
出版物タイトル(別表記)
岡山大学工学部紀要
27巻
1号
出版者
Faculty of Engineering, Okayama University
出版者(別表記)
岡山大学工学部
開始ページ
1
終了ページ
10
ISSN
0475-0071
NCID
AA10699856
資料タイプ
紀要論文
言語
English
論文のバージョン
publisher
査読
無し
Eprints Journal Name
mfe