Memoirs of the Faculty of Engineering, Okayama University 33巻 2号
1999-04-27 発行
神代 充
Graduate School of Okayama University
大崎 紘一
Faculty of Engineering, Okayama University
梶原 康博
Faculty of Engineering, Okayama University
Tano Masakazu
Faculty of Engineering, Okayama University
Okamoto Katsuyuki
Omron Okayama Co., Ltd.
Nishino Akira
Omron Okayama Co., Ltd.
Okamoto Asao
Omron Co., Ltd.
Nishimori Naoki
Omron Co., Ltd.
We propose the recognition method of bridge soldering base metal on the circuits by comparing CAD figure and input image of image processing to locate the soldering iron tip accurately to secure the high quality Firstly, three dimensional CAD assembly drawing of circuits which are assembled perpendicularly in each other is projected on an imaginary two dimensional screen which is vertical to the optical axis of the camera The projected image is used as the standard CAD figure to inspect the location of the bridge soldering base metal. The positions among the bridge soldering base metals show the line state. So this line (connecting line) is used as the reference line to inspect the location of the bridge soldering base metal. The characteristics of the standard figure are represented by the connecting line, edge line and center points of base metal. Secondly, the position and gradient of connecting line among bridge soldering base metals in the input image is estimated. And the position of base metal and assembly accuracy of circuit units are calculated by comparing the shape and position of each base metal with its standard figure based on the connecting line Furthermore, the length between the opposite edges of the base metals are calculated to inspect the positions and the assemble accuracy of circuit units.