このエントリーをはてなブックマークに追加
ID 15410
JaLCDOI
Sort Key
2
FullText URL
Author
Uno, Yoshiyuki
Nakajima, Toshikatsu
Okada Minoru
Abstract
Practical utilization of ram type electrical discharge machining in uninflammable fluid has been expected in place of inflammable kerosine type fluid for unmanned operation in a workshop. The electrical discharge machining performance in deionized water is experimentally investigated on the basis of the analysis of the crater generated by a single pulse discharge. The experimental analysis makes it clear that the electrical discharge machining performance in deionized water is greatly affected by the electrode polarity. The metal removal rate in the normal polarity machining is higher than that in reverse polarity machining, while the electrode wear rate in the normal polarity machining is greater than that in reverse polarity machining. Therefore the electrode polarity should be properly selected according to the purpose of machining.
Publication Title
Memoirs of the Faculty of Engineering, Okayama University
Published Date
1991-11-30
Volume
volume26
Issue
issue1
Publisher
Faculty of Engineering, Okayama University
Publisher Alternative
岡山大学工学部
Start Page
9
End Page
20
ISSN
0475-0071
NCID
AA10699856
Content Type
Departmental Bulletin Paper
OAI-PMH Set
岡山大学
language
English
File Version
publisher
NAID
Eprints Journal Name
mfe